gasoline portable generators: Blades

Thursday, October 6, 2011

24 Inch Turbotorque Aluminum Wind Turbine Blades (Set of 5)

24 Inch Turbotorque Aluminum Wind Turbine Blades (Set of 5)

Rate This Product :

High RPM Blades for Wind Power Generators! Introducing our aircraft-grade aluminum TurboTorque Wind Turbine Blades. TurboTorque blades are designed to spin very fast! If you're building your own residential wind turbine or small wind power generator using an Ametek motor, treadmill motors and other types of permanent magnet generators that require high RPMs, these blades are a great choice. If you live in a low wind area and need to get your permanent magnet motor/generator up to charging voltage, then these are your BEST choice. In high wind areas (typically greater than 12-14 mph) with a similar motor/generator as that described above, you should consider purchasing our 28 inch HyperSpin Wind Turbine Blades.Our TurboTorque 24 inch blades come with a stainless steel hub with a 17-mm inch center mounting hole. This allows you to easily mount your blades on any permanent magnet alternator or DC motor with a 17-mm inch shaft.

24 inch aircraft-grade aluminum wind turbine blades
Stainless steel 17 mm inch hub
Fasteners and everything needed for assembly!
Weather-resistant and will not rust or deteriorate.
Satisfaction guaranteed with a 30 day return policy!

Available at Amazon : Check Price Now!

*** Product Information and Prices Stored: Oct 07, 2011 13:46:30 ***

Tags : Generator Buying Guide diesel generator sale cheapest portable generators

Tuesday, June 21, 2011

35 inch WindGrabber Aluminum Blades (Set of 5)

Our Price :
Average Customer Review:

For generators with very large permanent magnet motors or 600-1200 Watt PMA's, our three aircraft-grade aluminum WindGrabber blades are designed for extremely high torque and power! When mounted, the swept area (diameter) of these blades is 80 inches (203 cm). These blades are designed to put out amps on larger motor/generator units. Because a larger rotor inherently spins slower, this blade set should not be used on units that have a "cut in" voltage higher than 250 rpm. Under no load, WindGrabbers will hit 200 rpm in about 6-7 mph wind. Additionally, it will begin spinning in approximately 1.5-2 mph wind! This is not the blade set that should be used on a modified Delco car alternator. This rotor is far too powerful for a Delco and will spin it out of control! Consider a set of five HyperSpin blades with a stainless steel hub with a 5/8 inch mounting hole, easily compatible with Delco alternators.